Coppers of Siberia (Siberia)

I bought in 2016. the house is 117 sq.m. Throughout the winter, the temperature in the house did not rise above 18, in frosts it reached 13. On the regulator, the position is only 4. You turn it on 5-6-7, he does not see them, the temperature in the boiler is maximum 48. He doesn’t turn on 2, he immediately turns off. And it turns out that from all positions only workers 3-4. Gas for 3 leaves 18 cubic meters per day, and for 4 27 cubic meters. there is a pump on the water. What is the reason for such disgusting work is not clear. Gas says the boiler is in good condition.

size and cost.

quality wants to be the best.

Knocked out a bolt. Turned on after the summer and water flowed.

Heats well.

He served a little more than 3 years.

I am a woman, I bought a boiler in Siberia in 2015, this does not include a fig. You press the thermostat to bleed the air, waiting 40 minutes, the result is zero. What to do???

Economically, you pay less than AOGV

Launch after 3 months

From the heading it is clear that the problems began as soon as brought home. I will describe the rest below since there are such windows for answers.

plus the fact that in the pilot burner mode it is very economical about one cube per day, although the previous one ate five cubes only on the wick.

began as soon as it began to dock the chimney in diameter of 140 mm, and there are no such adapters and the tinsmith had to be ordered from galvanizing, and now at setting 4 the loop has increased by 30 degrees, heating to 70 and cooling to 40 although at setting 3 everything was normal loop 6 gr what to do I don’t know something with the Italian filling happened although he was only two years old.

We needed a reliable boiler that could work in severe conditions. The gas pressure sometimes jumps in our mains (ShRP is still of Soviet assembly), the burners of the stoves even go out, and in addition, the voltage often drops or the electricity disappears altogether, in general, all the “virtues” of the provincial village. Therefore, Siberia-17 was the most suitable (I understand it in heat engineering, so I chose it myself).

After analyzing his work in the first three months, I can safely advise you to buy (or order it to others).

It works stably even in severe frosts, when the pressure (how can the regulator work at the gas distribution station?) Drops due to a lot of analysis.

I have met piezo-ignition more than once, and in most cases, in order to ignite the burner, you need a few clicks, then it works the first time.

Does not eat gas, profitability at the level.

Relatively inexpensive.

He also liked the appearance, the children even gave him the nickname “Darth Vader”, although due to the white color he looks more like an imperial attack aircraft.

Independence of power supply, accurate operation and low price

I did not see in three months

Floor boiler Siberia 11, purchased instead of the old gas boiler. The area of ​​the house is not big - 60 sq.m., in general this model is designed up to 110 sq.m., I took it specially with a margin, better more than less. A boiler was installed without forced circulation of water, this was done because the heating system has remarkable heat transfer and efficiency. Outwardly, the boiler looks decent, a white column, there is nothing superfluous, and the main attention is not particularly attracted to itself.

In management, I also did not find anything complicated. There are many sensors, the automation is all Italian and of high quality. For safety, I'm sure of this unit. Plus, the model is economical and completely non-volatile. I bought it for about 16,000 rubles. I advise you to purchase this Siberia 11 boiler, I was not disappointed in it, it suits how it works.

Easy to operate and copes well with its main effects

Cost

They built their house for a long time, we drove into it only six months ago. 6 months before the move, they installed a heating system, the boiler was taken from Siberia, a model called K17. We stopped at this option, due to the fact that we also needed hot water from the boiler, we did not install the gas column separately.
At first everything was fine, but then gas pops began to appear. Gas workers arrived, they cleaned the boiler and everything seemed to be gone. But now the situation is repeating itself again, this time I tried to clean the boiler myself, while everything seems to be normal, I don’t know how things will go next.

I also noticed one strangeness in the water supply. You turn on, for example, a hot tap and after 4-5 minutes cold water starts to flow from it. Reducing the stream, and the water starts to flow hot again. In general, the boiler is not bad, you can advise it, but there are problems with it too.

Beautiful design, good automation, easy control

There are problems with the boiler

Last summer, they decided to replace the old boiler with a new floor boiler from the manufacturer Siberia K17. We bought it on the advice of friends and gas workers. First of all, it became clear that the boiler is quite compact and easy to operate. It doesn’t take up much space; it’s much nicer to enter the kitchen now. The saving of our family budget with the advent of a new boiler also became noticeable.If earlier they paid about 4 thousand a month for gas, now 2-2.5 thousand rubles.

The amount for the year follows a decent one. Management is simple, the boiler works in only 7 modes. Where 1 means minimum heating, and 7, respectively, maximum operating mode. In winter, in frosts we set mainly to 6 mode, this is enough for the normal temperature in the apartment. We bought a boiler by the way for 15 thousand rubles, at a cost much more budget and more pleasant for a wallet.

Compact, easy to drive, economical

Design