Toilet bowls Santek

Very poor workmanship.

I did not see, did not feel.

Toilet bowl "Boreal anti-splash".

Quality is of no quality: the base is screwed, the mounting holes of the tank are offset relative to the toilet, the drain hole too, the lid does not sit in its place, there is a sharp edge protruding along the edge of the drain hole of the tank, the mounting washers are small - they fall into the holes, the float with a crack drowns, the cover with a seat protrude relative to the toilet forward 15 mm. In general, complete ...

I do not advise.

After installation, the toilet Boreal Sentec started to leak in the eyeliner. The reason is poor-quality earthenware flooding of the hole for the water inlet. Eliminated by placing a siphon (I do not know what the name of the water inlet is called) on the sealant. A month later, the water began to overflow.

The quality is disgusting to enter the quality control department behind the plant in the passport to indicate how to return the defective goods that were in use.

Orderly.

Noisy when filling the tank (similar to vibration) when almost full. Water leakage flowed together - a factory defect looks like a crack, but this is not a quality pouring with earthenware. Each month, water passes through a gasket in the inlet siphon.

No frills and no obvious stocks. Suitable in most Russian apartments. I ordered 2 immediately on Skype, it cost me a little lower compared to the unhealthy price on the market. It’s not a convenient conclusion to the sewers, but it’s possible that the crooked-arm plumbers in our house made water pipes.
I liked the coating of the toilet, that it washes well and does not stink, in principle this is enough for a good toilet.

Sometimes a button fuses, but this is a problem for many barrels.
The price is suitable for quality.

Does not stink, easy to clean, high-quality coating.

Inconvenient conclusion to the sewerage.

When repairing the toilet, the task arose of choosing a toilet, reading reviews and parameters for a long time, realizing that all manufacturers had jambs, they opted for a Santek Boreal toilet, anti-splash with a displaced hole in the center of the toilet =) Purchased for 4600r. Arriving home, I found that on the bottom of the tank, there are jambs of casting at the attachment points, I still did not understand a little, the recesses for the cone were made from the bottom of the tank, although the conical washers are installed from the inside. Having read about the through holes and the smell passing through them, I decided to carry out Hydraulic tests (as at work we carry out GI tanks) of the toilet cavities as soon as they brought home, it’s not enough to change anything.

1. Turned the toilet over, put it on a cardboard from a package and poured water to the maximum cavity connecting the waste outlet and the water into the toilet, connecting the partition, 30 minutes passed, draining the water is dry.

2.Having put the toilet bowl in the normal position on the bathroom bridge (having previously put sheets of paper on the bridge for leakage analysis), sealed the waste outlet from the toilet with packages + rubber bands + rope and poured a full toilet bowl under the seat itself to get the maximum column of liquid, corresponding to pressure.

After 2 hours, I drained the water, removed the toilet, everything is dry. (the only thing on the bottom of the toilet, in one place it was smeared as if trying to cover the seam, after the GI this place was a little wet, but decided that it was just condensation from humidity). GI toilet successfully carried out. When I installed the toilet, all my relatives put in the spare parts, but in order not to tempt fate, absolutely all the places of fasteners and gaskets were duplicated by sanitary sealant before the connection. The installation was done hastily, since after a couple of hours the guests were supposed to come, it was put into operation about an hour after the installation. all is successful, there are no leaks. We chose it precisely because I understood when choosing that the “anti-splash”, since it should initially work due to the minimum water level in the place of the funnel and special design, is not guaranteed by one of the manufacturers. At our toilet, waste products fall on the back wall and slide, of course, if you don’t sit down so that the axis of the hole is 5 points and the funnel will coincide.

You almost always have to work with a brush, as the maximum flow of water is directed along the sides to the front of the toilet, there’s a small stream along the back wall, BUT it doesn’t bother much, because before that there was a shovel toilet and they always worked like a brush, but 100% fun PLUSH missing. Washes off well, the only thing may not always be the first to wash off cat's feline, as they are dry and have good buoyancy =), the paper is washed off well, but we usually throw it in a bucket, in order to clean the sewer. No flushing was noticed. The conclusion is oblique, we did not need any transitions, I just inserted it into the plastic sewer pipe and additionally missed it with sealant.

When choosing, pay attention to the output of the toilet, the main parameter for choosing the toilet, all sizes are usually on the diagrams and sites. There is fogging of the tank, but this does not depend on the toilet bowl but on the humidity in the apartment, in addition, I noticed that there are two recesses on the back of the toilet bowl lid, for ventilation in the tank, the result is a more rapid equalization of the temperature of the water in the tank and toilet room. When installed in a hurry, the corner of the seat of the unisease was dropped and a corner was cracked because the duroplast turned out to be fragile, subsequently glued back, greased with sealant.

1 Price 4600r
2 The absence of holes that are not provided, the consequence of the lack of smell of sewage
3 Do not need extra. transitions for connection to the sewerage
4 No flushing
5 Washes off well and all

1 Inessential jambs on toilet seat castings
2 Fragile Duroplast
3 Rarely water leaks, eliminated by repeated flushing

I have been using this product for about 10 years. Everything still works, it does not leak. Well done manufacturers.

For 10 years it has not broken, does not flow.

From time to time over 10 years, the chrome on the plastic drain button has partially erased. The regular seat is good, but the seat cover is mounted on two pins, if you slightly slide the cover over them, then it is removed from the grooves, you often have to fix it, but now they may have different equipment. You can always buy a new seat in a store; the mount is standard.

We use one boreal toilet of the year 4-5. There are no complaints. Installed a good master. The second set in another place a year ago with anti-splash - also everything is in normal mode. There are many negative reviews about this product, but a person with brains, having read them, will understand that there is no manufacturer’s fault. In 99% - an incompetent master installer.

Great toilet, reliable system.

not detected.

We bought a toilet a week ago and have already changed the toilet lid twice. The price of the cover is like the floor of the toilet, and the quality is good. The lid cracked when the child sat on it, the child weighs 20 kg. What kind of quality?

No pluses!

Poor quality!

For me, the main thing in the toilet is the size, since the area of ​​our bathroom is very small and the overall device will simply not fit here. It was from these considerations that the Santek Rimini toilet was chosen, the cost of it by the way was affordable.
Good water pressure, although the tank is small, the flush is in a circle, the drain button is one. Earthenware is smooth, but in some places there are jambs, although if you take into account the low cost, you can not find fault.

The tank has flowed several times over the year, the husband removed the lid and adjusted. We think that we are to blame ourselves, most likely they were mistaken during the installation. Stickers on the toilet are crooked, they look untidy. I still do not like that the seat is constantly cold, you sit down and it becomes unpleasant. We bought a toilet for 3200 rubles.
It’s a normal toilet, it’s difficult to call it ideal, but it’s simple and affordable, its dimensions are compact.

inexpensive, compact

there are flaws

Having moved to a new apartment, we immediately decided to install a new toilet. A familiar plumber advised us to buy a toilet from a domestic manufacturer Santek (made in Chuvashia). Of all the options, we liked the Iris model the most.

White

During operation, the following was found out:

- flushes the toilet terribly, it turns out from the third, not earlier, washing the bowl does not go evenly;

- A very long time water is collected in the tank, you have to constantly wait and spend time;

- after 1.5 years, our toilet began to flow, so much so that a wet spot appeared on the neighbors under us on the ceiling. The plumber naturally fixed everything, but we had to pay for the repair of the ceiling and the call of the master.

So, do not buy Santek toilets, although their cost is cheap, ours cost 3.5 thousand rubles, but it is not worth it. One continuous torment with this woe-toilet.

5 months ago I bought a toilet from Santek called Boreal, I really regret it now. I really dislike him for many reasons:

- It is indicated that the toilet is with anti-splash, but there is nothing of the kind in fact.I don’t think that people should adapt to the toilet, I apologize for such details, but since we are discussing the toilet, I’ll say that when you go for a long walk, the spray will reach the priests, and this is not at all hygienic and far from a pleasant moment.

- Water is pouring constantly from the barrel, removed the lid from the barrel and found that the water is gaining more than normal, and the overflow accordingly goes into the drain hole.

- Plus, an unpleasant odor appeared in the toilet, my husband removed the toilet and smeared the entire bottom with silicone and epoxy glue.
I’ll tell you honestly, they would give it for free, wouldn’t take it, and I don’t advise you! The toilet is of terrible quality !!

cost

disgusting quality