Doors of Falko (Falko)

I think the comments here are unnecessary.

There are no positive nuances.

Not intended for private homes. Every winter is such a story.

The door of the Arctic Suite No. G05379 is of poor quality, freezes even at -12 ° C, condensation appears on the entire door leaf along the seal, on the threshold and on the door handle, ice appears at -20 ° C from the bottom, at -30 ° C and you can’t leave the house below until you warm the door with a good warm heater. The thermobox was also very poorly foamed, when installing and making holes for the anchor, the foam just fell down, so to say that this thermobox was not possible at all, I had to drive a lot of foam into the holes for the anchor. There are no adequate suggestions from Falco to eliminate these problems, only advice that you do at your own expense and do not want to guarantee anything at all, they don’t have any other gaskets, they’ll justify all kinds of excuses, it’s easier for you to tell them to go, buy and deliver .

not

The door of the Arctic Suite No. G05379 is of poor quality, freezes even at -12 ° C, condensation appears on the entire door leaf along the seal, on the threshold and on the door handle, ice appears at -20 ° C from the bottom, at -30 ° C and you can’t leave the house below until you warm the door with a good warm heater. The thermobox was also very poorly foamed, when installing and making holes for the anchor, the foam just fell down, so to say that this thermobox was not possible at all, I had to drive a lot of foam into the holes for the anchor. There are no adequate suggestions from Falco to eliminate these problems, only advice that you do at your own expense and do not want to guarantee anything at all, they don’t have any other gaskets, they’ll justify all kinds of excuses, it’s easier for you to tell them to go, buy and deliver .

These doors are not worth the money. I do not recommend others to take the door from this company.

Outside it looks good, but apparently not very inside.

The door of the Arctic Suite No. G05379 is of poor quality, freezes even at -12 ° C, condensation appears on the entire door leaf along the seal, on the threshold and on the door handle, ice appears at -20 ° C from the bottom, at -30 ° C and you can’t leave the house below until you warm the door with a good warm heater.The thermobox was also very poorly foamed, when installing and making holes for the anchor, the foam just fell down, so to say that this thermobox was not possible at all, I had to drive a lot of foam into the holes for the anchor. There are no adequate suggestions from Falco to eliminate these problems, only advice that you do at your own expense and do not want to guarantee anything at all, they don’t have any other gaskets, they’ll justify all kinds of excuses, it’s easier for you to tell them to go, buy and deliver .

Door installation was scheduled for 15 - 00 hours. We arrived at 17-00. They removed the old door. Started to install a new one - not included. Hollowed a wall by 5 centimeters. Dust pillar, all the poor neighbors did not know what to do. The noise is terrible. Set the door leaf, foamed. Everything. We left. They said when plastering. That is hollowed out, you will call - we will establish platbands.

Appearance is not bad.

It closes with difficulty, it is necessary to press it with force, although there was no such effect on the exhibition copy. Hollowed out holes for locks - it looks awful.

I ordered this door in the "door factory" in the summer. The price tag for 35 thousand rubles with installation. When configured in a store on the street. Nakhimova, a girl, the seller answered my question about locks knowingly that they only put locks not with flat keys, like they freeze, but locks with keys like Pinocchio's (with big keys). I hesitated but for some reason I got this information. This key subsequently tore all my pockets, and today in the first frost of November (-13) I found that not only was the lock covered in a chicken, but my mother didn’t feel cold from the siphon hole. Although I did not plan to arrange ventilation through the castle, but thanks to the Falk people they do not give suffocation. I also found that the narthex of the door around the perimeter to the other is 10-15 percent of the perimeter. And this is just the beginning. Winter is ahead.

Now about the measurement and installation. I experienced this with humor in the summer, as I am not a conflict person, and hoped that I would put an expensive but warm door into my house. But since it turned out to be expensive and not warm, as I had dreamed of before today's frost, it was like this, the arrived measurer measured the doorway and said with care that my threshold in the opening plus the threshold of the door itself gives a total threshold of decent height, but we all know that in Russia, two troubles of roads and thresholds and his proposal to cut my threshold to the height of the threshold of the box, I took positively, although he warned me that this was an additional cost.

He wanted the best, but apparently forgot to add the future size of the cut-off threshold to the size of the future door, since he came to measure with his wife and children and they constantly pulled him out of the car, and when I arrived at the store without calculating all the risks, I signed in the measuring sheet and agreed and with the size of the door and with the cutting of the threshold in the opening. The arrivals of the World of Doors (I realized that this was one gang with the Factory of Doors) on the appointed day tore off my old door (which, as I understand it, was no worse than the new one, also worked actively for inflow) cut down the threshold in the opening clearly by the technical assignment and inserting a new box into the opening, they began to actively anchor it, not paying attention to the fact that the box’s panel does not close the gap from the top of the opening.

To my question about the gap, they cheerfully replied that I Pinocchio with a wooden head signed the act of measurement and now get the door with a hole on top and a shiny key that tore all my pockets.True, before leaving, they took pity on me and gave me the poor fellow some useful, and most importantly free tips on how to close the gap from above.

It was in the summer, but today in the first frost (-13) everything was still freezing. That's the kind of door I got from FAL and Co. Probably have to hang a felt canvas with a drawn hearth.

The door works as forced ventilation to the house.

No recuperation system (preheating of air in the supply)

Tyapkins-lyapkins spoil a good design with disgusting laying of insulation - it’s simply not near the locks, but everywhere thin.

Reliable sealants.

A strong deviation from the exhibition samples with good filling with insulation makes the Arctic NEW a door for SubTropics, and not for Siberia ... and this is sad.

The surveyor advised how to do it better, namely to remove the concrete threshold from the builder and put the door higher in height. The installers did not arrive at the agreed time. I had to call them myself. The next time they were late and also did not call. The door was set efficiently. In the calculator on the website, the Elegance # 16 finish does not look right. Namely: it is not entirely clear whether it is a mirror or not, at the end of the mirror there are not enough metal inserts! Some finishes are displayed with poor detail, as a result, you can’t make out what they put out of themselves, for example Elegance No. 44

+ Appearance. Large selection of door finishes.
+ Large selection of door sizes without overpayments.

- Soundproofing. I would like better. For the money given, you can find better, but the pluses described above will no longer be. If compared with the door from the builder, then this is "heaven and earth." By the way, the case (profile) of the door the installers falsely foam.

For the representative of the company, door number No. 555 was not entirely successful. Three years passed, the door closes almost as tightly, well, the rubber bands did not come as promised. For 3 years he changed the castle, stood Turetsky and stuck from the very beginning, where he worked poorly for 3 years. And it was just either a marriage or something. Now the Chinese ARMADILLO handle has broken, just the metal burst. On the box from the handle is a 5-year warranty. What I was offered at Falco, but essentially nothing. replace the handle with a good one for 2100+ work of the master + re-drill the handle if necessary (suppliers have changed). And what I wanted, I wanted the company to take over the cost of the pen. It seems to me as an engineer the handle would not break off with the correct door adjustment and a normal seal. Falko, your way out, only without any reply. The door number I indicated above !!!

The largest is the manufacture of custom size doors

If the company is responsible for its product, then give a 3 year warranty!

The doors are really nothing, good installers, BUT one thing but - this is a terrible receptionist at the reception of orders. There is no culture of communication with the client, after talking with her for 5 minutes, I really don’t really want to order any door. Communicates with the client as if the client owes her something.

Door quality

Administrator

The installation of the entrance street door in a residential building at this organization turned into a months-long horror of communication with a huge number of incompetent, ill-bred characters - Falco workers
These miracle workers do not like their work
They do not know how and do not want to fulfill it
Starting from surveyors - 3 times arrived
Continuing the installers - 3 times came
Finishing the management of the company - 2 times came

So in order:
- door Arctic ordered and paid the price of 40 tr
- brought to the object - the door is not the size of the opening
- you have to redo the opening, which completely spoils the aesthetics of the view
- they begin installation - it does not work out due to the curvature of the installers to foam qualitatively and completely at the joints of the doorway and the door frame
- remake under the customer’s kicks more than once - the result only worsens
- slots in the finger with a thickness give a minus temperature on the surface inside with ice and the inability to open the door lock in bad weather
- according to the readings of the thermal imager - on the door surface is the minus temperature indoors, where + 25C
- all calls to this office - rudeness in response and unwillingness to fix the problem

If you want to shake your nerves, spend a lot of money on strange products called the doors of the Arctic and wait for months to return them - welcome to Falco

not

completely full