Axton bulk floor

I want to supplement my previous review. After writing it, I began to fill the floor in the room with 35 squares. Only the worst impressions remained. The mortar dries really fast. Already 20 minutes after pouring begins to harden.

Another nuance, before starting to fill, the entire surface must be dusted off. That is, do not just sweep the coating with a broom, apply a deep penetration primer to significantly increase adhesion.

After pouring, it is necessary to very carefully roll out the surface with a needle roller and distribute the solution more evenly and draw all the air out of it. The premises must be closed for the next day. so that there are no drafts, the surface will crack.

good ductility of the material

setting too fast

The spreadability of the glue is good. Filled the kitchen with 6 square meters, received a high-quality uniform coating. Unfortunately, many beginners make the same mistake, believing that the floor itself should scatter in the corners. In fact, quite a lot of effort is needed to level the floor. First you need to distribute the bulk floor throughout the room, and then the rule to completely level it. When buying, pay special attention to the concentration of the dry mixture. The second time they took us, we got caught from a soaked party. Combine the dry mixture were some suspicious lumps, which was very difficult to stir.

flowability is quite abnormal, affordable cost

It dries very quickly, it simply will not work for filling rooms of a large area (more than 20 sq. M.)

I make repairs in the apartment. Since the floor area throughout the apartment is quite significant, many people decided to take the budget option to level the mixture. To begin with, I poured a bathtub, toilet, kitchen, corridor in small rooms. Everything was poured without the use of markers. Two Worked. My wife and I are the wife of a dead man in a large bucket. Kneading completed immediately on the bag. There are five and a half liters of water per 11 kilogram bag. The given amount of water is empirically. When they did everything according to the instructions, the mixture left very thick and practically did not spread.

The material sets very quickly after 10 minutes, it could already be walked on with pepper

Quickly grasps this plus and minus

Some places during drying gives a black film
Dries for a long time, especially on thick layers
For large rooms not suitable

I am a professional finisher and face repairs every day. For all the construction products of Axton and bulk floors in particular, I can give only the most positive recommendations. The last few years I have been trying to work only on behalf of the customer if the customer has no particular preference for building materials.

It is very simple to work with a bulk floor. The material rolls well, without special efforts does not twist, does not crumple, does not create various discomfort conditions.
Materials are always at due quality levels. If it says 1.3m / 1mm per bag, then it will be so without excuses for the terrain

Not found For so many tapes