A comment
It poured a room of 20 m2 with a layer of an average thickness of 0.5 cm, in places up to 1 cm. It was flooded quite quickly, the surface was carefully leveled. And during drying, he went cracks and bubbles. After drying, I picked up a little spatula near the door and chopped off a piece by half a square no less, so in 30 minutes I poked out half of the room, and the rest had 10 minutes of perforating.
But the fault in this is completely mine, I admit, I covered the base with a primer only once, and even then I took the cheapest of Leroy. The second time I covered the floor 2 times with Ceresite TST17 with a pause of 4 hours for complete drying. And only after that was the Knauf-tribone flooded. This time there were few bubbles in only two places around the edges. It has been already 3 weeks, without cracks and chips, I will soon lay down the laminate.
pros
dries fairly quickly, gives an even, durable layer, easy to work
Minuses
very demanding on the preparation of the base, it is impossible to save on the primer